This Dreafly air ducting hose kit moves warm air from a diesel heater to where you need it. It has 11 pieces and a 60mm bore. It costs £13.00.
The pack holds 2 aluminium foil ducts that measure 50-100cm each. You also get 2 plastic vent outlets, 1 T piece and 4 metal hose clips. It fits Eberspacher, Webasto, Propex and Dometic heaters.
Will it suit your vehicle? It can be used in cars, trucks, boats and farm or industrial machinery. The vent fascia rotates 360 degrees so you can aim the heat. No instructions are included and professional fitting is advised.
Aluminium foil ducting - Each of the 2 ducts is 50-100cm long with a 6cm diameter. Aluminium foil handles heat well. It is mainly used for 2kW diesel air heaters. One buyer said the parts do not melt like other ducting they had tried before.
Rotating vent outlets - The 2 plastic outlets are 10cm tall with a 6cm diameter. The front fascia turns 360 degrees. Why does that matter? You can point warm air at a driver's feet or a windscreen. The fascia also comes off to reach the screw holes.
T piece splitter - The black plastic T piece suits ducting with a 6cm internal diameter. It splits one heater flow into two. That lets you warm a cab and a sleeping area from a single heater. It saves you buying and running a second unit.
Wide heater fitment - The kit suits Eberspacher, Webasto, Propex and Dometic heaters. Is that useful? Yes because these are common names in diesel air heaters. One French buyer fitted it to a Webasto and said it matched the description. It can also replace old or damaged ducting.
Heat and corrosion resistance - The ducting and metal parts are made to resist high temperature and corrosion. Heater ducting sits close to hot air all day so weak parts can warp. One buyer reported no heat distortion on their setup. The same ducting also carries cold air.
Metal hose clips - Four 6cm metal clips hold the ducting onto the outlets and T piece. Loose joints leak warm air and lose heat. One buyer mounted the outlets into 18mm board and found the collar only just long enough to clamp. Check your panel thickness first.
The contents list names 2 heater ducts, 2 vent outlets, 1 T pipe and 4 metal hose clips. The listing counts the set as 11 pieces. The itemised parts add up to 9, so check the contents against your plan before you order.
Each part is made for 6cm ducting. Everything is black. The kit is sold as one set.
The listing says it suits Eberspacher, Webasto, Propex and Dometic warm air ducting. It is mainly meant for 2KW diesel air heaters. One buyer fitted it to a Webasto and said it matched the description.
Does your heater use a different duct size? Then it will not fit. Measure your heater outlet first. Every part here is 6cm.
The ducting is aluminium foil with a 6cm diameter. Length is given as 50cm to 100cm. The seller notes a measuring difference of about 1.3cm to 2.5cm because lengths are measured by hand.
It handles hot and cold air. One buyer called the length of ducting good. Plan your route and cut length before you start.
The listing describes the kit as high temperature resistant and corrosion resistant. It gives no maximum temperature figure. Treat that as unknown.
Buyer feedback helps here. One said the parts do not melt like some others they had tried. Another saw no heat distortion on their set.
The vent outlet is plastic and 10cm high. It takes 6cm ducting. The front fascia comes off so you can reach the screw holes and fix it in place.
The fascia then rotates 360 degrees. That lets you aim warm air at the seat area or at your feet. One buyer fitted the kit in a 2022 Ducato because the driver's footwell had no heating.
The black plastic T piece splits the warm air from your heater into two paths. It suits ducting with a 6cm internal diameter. You could feed one vent in the cab and one further back from a single heater.
One buyer said it helped warm air circulate. Keep in mind that splitting the flow shares the same heater output between both vents.
The seller calls it easy to install. No instructions are included. The listing also says professional installation is highly recommended. That matters because this is a fuel-burning heater system.
Check one thing before you cut any panel. The vent outlet collar is fairly short. One buyer mounted the outlets in 1.8cm board and said there was only just enough collar left to clamp the pipe. Thicker panels may leave too little.
The listing names cars, trucks, boats, agricultural machinery, heavy machinery and industrial machinery. It also suits replacing old or damaged ducting.
It rates 4.4 out of 5 from 188 ratings. About 72% are five star and 5% are one star. Amazon lists a 30-day right of return on many products. Check the return details on the listing for conditions. It is sold by a third-party seller. The size listed is 16.5 x 11 x 5cm and the colour may differ slightly from the photos.
| Specification | Detail |
|---|---|
| Brand | Dreafly |
| Manufacturer | Dreafly |
| Model number | zhuk_uk221052_019500000129420211208 |
| Set name | Car Heater Duct Kit (5 Pieces) |
| Number of pieces | 11 |
| Unit count | 1 |
| Number of packs | 1 |
| Colour | Black |
| Overall material | Aluminium, plastic and metal |
| Exterior finish | Aluminium |
| Item dimensions (L x W x H) | 16.5 x 11 x 5cm |
| Size | 6cm |
| Connector type | Threaded fitting |
| Thread size | 6cm |
| Thread type | UN |
| Warm air ducting material | Aluminium foil |
| Warm air ducting length | 50 to 100cm |
| Warm air ducting diameter | 6cm |
| Vent outlet material | Plastic |
| Vent outlet height | 10cm |
| Vent outlet diameter | 6cm |
| Vent outlet fascia | Removable and rotates 360 degrees |
| T pipe material | Plastic |
| T pipe colour | Black |
| T pipe diameter | 6cm (for 6cm internal diameter ducting) |
| Hose clip material | Metal |
| Hose clip diameter | 6cm |
| Contents | 2 heater ducts, 2 vent outlets, 1 T pipe, 4 hose clips |
| Compatible heaters | Eberspacher, Webasto, Propex, Dometic |
| Intended heater size | 2KW diesel air heaters |
| Instructions included | No |
